Watch out for:

• Are you taking too long between Keystrokes?
• The keypad gives no confirmation or prompts until all keystrokes are completed.
• Do you have the right Authority?

Contents…

·        General Notes

·        Programming a DURESS User Code (codes 03-48)

·        Program the user code to be DURESS

·        Enable duress to report

General Notes

Ø       Only the Master code can be used to assign, change, or delete the secondary 4-digit user codes.

Ø       The following steps must be done from outside the keypad program mode (normal operation)

Ø       Each of these sequences must be executed with no pauses between keystrokes.

Programming a DURESS User Code (codes 03-48)

At the keypad, enter Master Code + 8 + [user position] + 4-digit User Code.

You will get a single beep to verify the entry was accepted.

The user position will be a 2-digit entry of 03, 04, 05, etc…

            For example, if the master code is 1234 and wants to add user#10 as a duress code of 2580,

Key the following: 1234 810 2580

Program the user code to be DURESS

Other codes may be changed to become duress codes by keying:

                  Master Code + 8 + [user position] +  # 13

You will get a single beep to verify the entry was accepted.

The user position will be a 2-digit entry of 03, 04, 05, etc…

For example, if the master code is 1234 and wants to make user #10 a standard code,

Key the following: 1234 810 #13

Enable duress to report

In Zone programming (*56), you need to enable a report code for zone #92.